LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1343 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Valve Spring, Retainer, and Seal >> Installation

Valve Spring, Retainer, and Seal: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the Valve Stem Oil Seal Installer, install the new valve seal.
    NOTE: Lubricate the valve guide with clean engine oil.
    Fig 1: Installing Valve Seal
    G06263428Courtesy of FORD MOTOR CO.
  2. Using the Valve Spring Compressor, install the valve spring, retainer and key.
    NOTE: If the components are to be reinstalled, they must be installed in their original positions or damage to the engine may occur.
    Fig 2: Identifying Valve Spring, Retainer & Key
    G06263429Courtesy of FORD MOTOR CO.
  3. Install the camshaft roller followers. For additional information, refer to Removal and Installation .
scientia non olet · About LEMON Manuals