LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Starting System -- Diesel Engine -- F250-F550 Super Duty 6.0L) >> Diagnosis And Testing >> Starting System >> Component Tests >> Starter Solenoid

Starter Solenoid

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative cable.
  2. Using the Digital Multimeter, check the windings of the solenoid as follows:
    • Measure the resistance between the starter motor ground terminal and the solenoid case. The resistance reading should be approximately 0.95 ohms.
    • An extremely high resistance reading indicates a break or fault in winding continuity. A very low resistance reading indicates a short or ground in the winding circuit. Either condition is cause for installation of a new solenoid assembly.
scientia non olet · About LEMON Manuals