LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1316 (Parking Brake And Actuation) >> Removal And Installation >> Parking Brake Cable - LH >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the tension on the rear parking brake. For additional information, refer to Parking Brake Cable Tension Release .
  2. Disconnect the RH parking brake cable from the equalizer.
  3. Disconnect the LH parking brake cable from the intermediate parking brake cable at the cable union.
  4. Compress the tabs and disconnect the parking brake cable conduit from the LH bracket assembly.
    5. Fig 1: Compressing Tabs & Disconnecting Parking Brake Cable Conduit From LH Bracket Assembly
    GF0044698Courtesy of FORD MOTOR CO.
  5. Release the rear parking brake cable from the parking brake actuating lever and remove the cable.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals