LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1314 (Vehicle Dynamic Systems) >> Removal And Installation >> Wheel Speed Sensor - Front >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the brake disc. For additional information, refer to FRONT DISC BRAKE article.
  2. Disconnect the front wheel speed sensor harness connector.
  3. Disconnect the front wheel speed sensor wire from the front brake hose.
  4. Remove the wheel speed sensor harness bolt.
    • To install, tighten to 9 Nm (80 lb-in).
  5. Remove the 2 bolts and the front wheel speed sensor assembly.
    • To install, tighten to 9 Nm (80 lb-in).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals