LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1311 (Rear Drive Axle/Differential - DANA 60 And 70) >> In-Vehicle Servicing >> Rear Wheel Bearing and Axle Shaft Seal - Semi-Floating Axle >> Installation

Rear Wheel Bearing and Axle Shaft Seal - Semi-Floating Axle: Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the new rear wheel bearing with axle lubricant.
  2. Using the Rear Axle Bearing Installer and Handle, install the rear wheel bearing.
    3. Fig 1: Installing Rear Wheel Bearing Using Rear Axle Bearing Installer & Handle
    GF0044648Courtesy of FORD MOTOR CO.
  3. Lubricate the lip of the new axle shaft oil seal with grease.
  4. Using the Rear Axle Oil Seal Installer and Handle, install the new axle shaft oil seal.
    5. Fig 2: Installing New Axle Shaft Oil Seal Using Rear Axle Oil Seal Installer & Handle
    GF0044649Courtesy of FORD MOTOR CO.
  5. Install the axle shaft. For additional information, refer to Axle Shaft - Semi-Floating Axle .
scientia non olet · About LEMON Manuals