LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1302 (Automatic Transmission - 5R110W (TORQSHIFT(R))) >> In-Vehicle Servicing >> Transmission Insulator and Retainer >> Installation

Transmission Insulator and Retainer: Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the transmission insulator and retainer.
    1. Position the transmission insulator and retainer.
    2. Lower the transmission onto the transmission insulator and retainer.
    2. Fig 1: Transmission Support Insulator
    GF0012409Courtesy of FORD MOTOR CO.
    NOTE: It may be necessary to raise the back of the transmission slightly in order to install the bolts.
  2. Loosely install the transmission insulator and retainer bolts.
    3. Fig 2: Identifying Transmission Support Insulator Bolts
    G03889100Courtesy of FORD MOTOR CO.
  3. Loosely install the transmission insulator and retainer nuts.
    4. Fig 3: Identifying Transmission Support Insulator Nuts
    G03889099Courtesy of FORD MOTOR CO.
  4. Tighten the transmission insulator and retainer bolts and nuts to 94 Nm (69 lb-ft).
    5. Fig 4: Transmission Insulator Bolts & Nuts
    GF0012410Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals