Transmission Drive Cycle Test: Notes

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Always drive the vehicle in a safe manner according to driving conditions and obey all traffic laws.

NOTE: The Transmission Drive Cycle Test must be followed exactly. Malfunctions must occur 4 times consecutively for the shift error DTC to be set. Torque Converter Clutch (TCC) failures must occur 5 times consecutively for a continuous TCC DTC to be set.

NOTE: When carrying out the Transmission Drive Cycle Test, refer to the Solenoid Operation Chart for correct solenoid operation.

After carrying out the Self Test, use the Transmission Drive Cycle Test for checking continuous codes.

Record and then erase the Self Test codes.
Warm the engine to normal operating temperature.
Make sure the transmission fluid level is correct.
With the selector lever in Overdrive (Circle D), moderately accelerate from stop to 80 km/h (50 mph). This allows the transmission to shift into 5th gear. Hold the vehicle speed and Throttle Position (TP) steady for a minimum of 15 seconds.
With the transmission in 5th gear and a steady vehicle speed and TP, lightly apply and release the brake pedal enough to operate the stop lamps. Hold the vehicle speed and TP steady for a minimum of 15 seconds.
Brake to a stop and remain stopped for a minimum of 20 seconds.
Repeat Steps 4 through 6 at least 5 times.
Carry out Self Test and record continuous codes.