LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (Four-Wheel Drive Systems (ESOF) - F250-F550 Super Duty) >> Removal And Installation >> Four-Wheel Drive (4WD) Control Module >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Prior to removal of the four-wheel drive (4WD) control module, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new module once installed. For additional information, refer to MODULE CONFIGURATION .
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Open and lower the glove box compartment.
  3. Disconnect the connectors from the 4WD module.
    Fig 1: Disconnecting Connectors From 4WD Module
    G03923813Courtesy of FORD MOTOR CO.
  4. Remove 2 nuts and the 4WD module.
    Fig 2: Removing 4WD Module Nuts
    G03923814Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals