LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1293 (Engine - 6.8L) >> In-Vehicle Servicing >> Crankshaft Rear Seal >> Installation

Crankshaft Rear Seal: Installation

WARNING: This page is about a different car, the 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the crankshaft rear seal with clean engine oil prior to installation.
  1. Using the special tools, install a new crankshaft rear seal.
    2. Fig 1: Using Special Tools To Install New Crankshaft Rear Seal
    G04583928Courtesy of FORD MOTOR CO.
    NOTE: Lubricate the crankshaft oil slinger with clean engine oil prior to installation.
  2. Using the special tools, install a new crankshaft oil slinger.
    3. Fig 2: Installing Crankshaft Rear Oil Slinger Using Special Tools
    G03920154Courtesy of FORD MOTOR CO.
  3. Install the engine rear cover plate.
  4. Install the flexplate. For additional information, refer to Flexplate .
scientia non olet · About LEMON Manuals