LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1291 (Automatic Transmission - 4R70E/W, 4R75E/W) >> In-Vehicle Servicing >> Digital Transmission Range (Tr) Sensor >> Removal

Digital Transmission Range (Tr) Sensor: Removal

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Disconnect the digital transmission range (TR) sensor electrical connector.
  3. Disconnect the selector lever cable from the manual control lever.
    4. Fig 1: Selector Lever Cable At Manual Control Lever
    GF0012354Courtesy of FORD MOTOR CO.
  4. Remove the manual control lever.
    1. Remove the manual control lever outer nut.
    2. Remove the manual control lever.
    5. Fig 2: Manual Control Lever & Nut
    GF0003476Courtesy of FORD MOTOR CO.
  5. Remove the digital TR sensor bolts and sensor.
    6. Fig 3: Identifying Digital TR Sensor And Bolts
    G04584370Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals