LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1291 (Automatic Transmission - 4R70E/W, 4R75E/W) >> In-Vehicle Servicing >> Digital Transmission Range (Tr) Sensor >> Installation

Digital Transmission Range (Tr) Sensor: Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosely install the digital TR sensor bolts and sensor.
    2. Fig 1: Identifying Digital TR Sensor And Bolts
    G04584370Courtesy of FORD MOTOR CO.
    NOTE: The manual shift lever must be in the NEUTRAL position.
  2. Using the special tool, align the digital TR sensor slots. The tool is designed to fit snug.
    3. Fig 2: Aligning Digital TR Sensor Slots Using Special Tool (307-351)
    G04584268Courtesy of FORD MOTOR CO.
    CAUTION: Tightening one screw before tightening the other may cause the digital TR sensor to bind or become damaged.
  3. Tighten the digital TR sensor bolts.
    • Tighten to 9 Nm (80 lb-in).
    4. Fig 3: Aligning Digital TR Sensor Slots With Special Tool
    G04584269Courtesy of FORD MOTOR CO.
  4. Install the manual control lever.
    1. Position the manual control lever.
    2. Install a new manual control lever outer nut.
      • Tighten to 33 Nm (24 lb-ft).
    5. Fig 4: Manual Control Lever & Nut
    GF0003477Courtesy of FORD MOTOR CO.
  5. Connect the selector lever cable end to the manual control lever with the manual control lever in the NEUTRAL position.
    6. Fig 5: Selector Lever Cable At Manual Control Lever
    GF0012354Courtesy of FORD MOTOR CO.
  6. Install the digital TR sensor electrical connector.
scientia non olet · About LEMON Manuals