LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1290 (Engine Ignition - 4.6L (2V) And 5.4L (2V)) >> Removal And Installation >> Ignition Coil-On-Plug >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine cover. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  2. Remove the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
  3. Disconnect the ignition coil electrical connector.
  4. Remove the bolt and the ignition coil.
    • To install, tighten to 6 Nm (53 lb-in).
  5. To install, reverse the removal procedure.
    • Apply dielectric compound to the inside of the coil boots.
scientia non olet · About LEMON Manuals