LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1287 (Engine - 4.6L And 5.4L) >> In-Vehicle Servicing >> Camshaft Roller Follower >> Installation

Camshaft Roller Follower: Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the special tool between the valve spring coils to protect the valve stem seal from damage.
    2. Fig 1: Installing Special Tool Between Valve Spring Coils
    G03962476Courtesy of FORD MOTOR CO.
    CAUTION: The camshaft roller followers must be installed in their original locations. Failure to follow these instructions may result in engine damage.
    NOTE: Do not allow the valve keepers to fall off the valve or the valve may drop into the cylinder. If a valve drops into the cylinder, the cylinder head must be removed. For additional information, refer to Engine .
    NOTE: It may be necessary to push the valve down while compressing the spring.
    NOTE: Lubricate the camshaft roller follower with clean engine oil prior to installation.
  2. Using the special tool, compress the valve spring and install the camshaft roller follower.
    3. Fig 2: Compressing Valve Springs Using Special Tool (303-567)
    G04612479Courtesy of FORD MOTOR CO.
  3. Repeat the previous 3 steps for each camshaft roller follower being serviced.
  4. If servicing the RH cylinder valvetrain components, install the RH valve cover. For additional information, refer to Valve Cover - RH, 4.6L  or Valve Cover - RH, 5.4L .
  5. If servicing the LH cylinder valvetrain components, install the LH valve cover. For additional information, refer to Valve Cover - LH .
scientia non olet · About LEMON Manuals