LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1279 (Steering Column Switches) >> Removal And Installation >> Ignition Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Depower the supplemental restraint system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM article.
  2. Remove the steering column opening cover and the instrument panel LH knee bolster. For additional information, refer to Instrument Panel - Exploded View in INSTRUMENT PANEL AND CONSOLE article.
  3. Disconnect the ignition switch electrical connector.
  4. Remove the 2 ignition switch screws and the ignition switch.
    • To install, align the ignition switch with the slot and index mark on the steering column and tighten the screws to 6 Nm (53 lb-in).
  5. To install, reverse the removal procedure.
  6. Repower the SRS. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM article.
scientia non olet · About LEMON Manuals