LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1273 (Wipers And Washers) >> Removal And Installation >> Washer Pump and Reservoir >> Removal

Washer Pump and Reservoir: Removal

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery tray. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  2. Remove the windshield wiper reservoir nut and bolt.
    • To install, tighten to 4 N.m (35 lb-in).
  3. Disconnect the filler hose from the reservoir.
  4. Disconnect the washer pump electrical connector and wiring harness locator.
    5. WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
    NOTE: If necessary, drain the windshield washer reservoir after removal.
  5. Disconnect the windshield washer hose and remove the washer pump and reservoir.
    6. CAUTION: Do not operate the windshield washer pump before filling the windshield washer reservoir. Failure to do so could result in premature pump failure.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals