Pinpoint Test AO: The Roll Stability Control (RSC) Warning Chime Is Inoperative

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

AO1 CHECK THE RSC WARNING CHIME
NOTE: The RSC warning chime operation can be verified only when the traction control/stability control warning indicator is on or the SERVICE RSC NOW message is displayed in the integrated circuit display (odometer).
- Fasten the driver safety belt.
- Key in ON position.
- Does the chime sound for 30 seconds after the key was turned to the ON position?
1. YES : The system operates correctly at this time.
2. NO : Go to AO2.
AO2 VERIFY THE KEY-IN-IGNITION WARNING CHIME OPERATION
- Key in OFF position.
- Open the driver door with the key in the ignition lock cylinder.
- Does the key-in-ignition warning chime sound?
1. YES : Go to AO3.
2. NO : Go to Pinpoint Test AM .
AO3 CHECK FOR CORRECT INSTRUMENT CLUSTER (IC) OPERATION
- Disconnect all the instrument cluster (IC) connectors.
- Check for:
  - corrosion
  - damaged pins
  - pushed out pins
- Connect all the instrument cluster (IC) connectors and make sure they seat correctly.
- Operate the system and verify the concern is still present.
- Is the concern still present?
1. YES : INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) . TEST the system for normal operation.
2. NO : The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.