DTC Charts

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

INSTRUMENT CLUSTER (IC) DTC CHART

DTC	Description	Action
B1015	CEI Unconfigured	REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
B106E	Solid State Driver Disabled Due to Short Circuit	Go to Pinpoint Test AE .
B1202	Fuel Sender Circuit Open	Go to Pinpoint Test B .
B1204	Fuel Sender Circuit Short to Ground	Go to Pinpoint Test B .
B1205	EIC Switch-1 Assembly Circuit Failure	VERIFY that the instrument cluster (IC) bezel is aligned correctly and the SELECT/RESET button is not binding. REPAIR as necessary. If the switch is not binding, INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) .
B1213	Anti-Theft Number of Programmed Keys Is Below Minimum	REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
B1304	Accessory Delay Relay Coil Circuit Short To Battery	REFER to GLASS, FRAMES AND MECHANISMS article.
B1315	Battery Saver Relay Coil Circuit Short To Battery	REFER to INTERIOR LIGHTING article.
B1317	Battery Voltage High	REFER to CHARGING SYSTEM - GENERAL INFORMATION AND DIAGNOSTICS article.
B1318	Battery Voltage Low	Go to Pinpoint Test AF .
B1319	Driver Door Ajar Circuit Failure	REFER to INTERIOR LIGHTING article.
B1327	Passenger Door Ajar Circuit Failure	REFER to INTERIOR LIGHTING article.
B1342	ECU Is Faulted	NOTE: If other DTCs are present, REPAIR them before installing a new component. CLEAR the DTCs. REPEAT the self-test. If DTC B1342 is retrieved again, INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) .
B1352	Ignition Key-In Circuit Failure	Go to Pinpoint Test AM .
B1360	Ignition Run/ACC Circuit Open	Go to Pinpoint Test AG .
B1373	Illuminated Entry Relay Short To Battery	REFER to INTERIOR LIGHTING article.
B1600	PATS Ignition Key Transponder Signal Is Not Received	REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
B1601	PATS Received Incorrect Key-Code From Ignition Key Transponder	REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
B1602	PATS Received Invalid Format Of Key-Code From Ignition Key Transponder	REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
B1681	PATS Transceiver Module Signal Is Not Received	REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
B1868	Lamp Air Bag Warning Indicator Circuit Failure	INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) .
B2103	Antenna Not Connected	REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
B2141	NVM Configuration Failure	REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
B2143	NVM Memory Failure	CLEAR the DTCs. REPEAT the self-test. If DTC B2143 is retrieved again, INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) .
B2431	Transponder Programming Failed	REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
B2477	Module Configuration Failure	CARRY OUT the programmable module installation to configure the instrument cluster (IC). REFER to MODULE CONFIGURATION article. CLEAR the DTCs. REPEAT the self-test. If DTC B2477 is retrieved again, INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) .
B2479	Park Brake Switch Circuit Short to Ground	Go to Pinpoint Test K .
B2658	Wait to Start Warning Indicator Circuit Open	CLEAR the DTCs. REPEAT the self-test. If DTC B2658 is retrieved again, INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) .
C1093	Traction Control Disable Switch Circuit Failure	REFER to VEHICLE DYNAMIC SYSTEMS article.
C1105	Traction Control Disable Lamp Circuit Short to Battery	REFER to VEHICLE DYNAMIC SYSTEMS article.
P1139	Water In Fuel Indicator Circuit	CLEAR the DTCs. REPEAT the self-test. If DTC P1139 returns, INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) .
U0002	High Speed CAN Communication Bus Performance	CLEAR the DTCs. REPEAT the self-test. If DTC U0002 returns, REFER to MODULE COMMUNICATIONS NETWORK article.
U0011	Medium Speed CAN Communication Bus Performance	CLEAR the DTCs. REPEAT the self-test. If DTC U0011 returns, REFER to MODULE COMMUNICATIONS NETWORK article.
U0100	Lost Communication With ECM/PCM	Go to Pinpoint Test AH .
U0101	Lost Communication With TCM	Go to Pinpoint Test AI .
U0121	Lost Communication With Anti-Lock Brake System (ABS) Control Module	Go to Pinpoint Test AJ .
U0151	Lost Communication With Restraints Control Module (RCM)	Go to Pinpoint Test AK .
U0168	Lost Communication With Vehicle Security Module (VSM)	Go to Pinpoint Test AL .
U2023	Fault Received From External Node	U2023 is set when a module receives invalid network data from another module with a faulted input. RETRIEVE and REPAIR all non-network DTCs in the other modules on the network. REFER to MULTIFUNCTION ELECTRONIC MODULES article for a list of all DTCs.
U2050	No Application Present	CLEAR the DTCs. REPEAT the self-test. If DTC U2050 returns, REFER to MODULE CONFIGURATION article.
U2510	CAN - Invalid Data for Vehicle Security	REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
U2511	CAN - Data Mis-Match (Receive data does not match expected)	REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
All other DTCs	-	REFER to MULTIFUNCTION ELECTRONIC MODULES article.

PCM DTC CHART

DTC	Description	Action
P0457	Evaporative Emission System Leak Detected (fuel cap loose/off)	Go to Pinpoint Test S .
P0460	Fuel Level Sensor A Circuit	REFER to the appropriate Engine Performance article first. If sent here from the PC/ED manual, go to Pinpoint Test B .
P0461	Fuel Level Sensor A Circuit Range/Performance	REFER to the appropriate Engine Performance article first. If sent here from the PC/ED manual, go to Pinpoint Test B .
P0462	Fuel Level Sensor A Circuit Low	REFER to the appropriate Engine Performance article first. If sent here from the PC/ED manual, go to Pinpoint Test B .
P0463	Fuel Level Sensor A Circuit High	REFER to the appropriate Engine Performance article first. If sent here from the PC/ED manual, go to Pinpoint Test B .
All other DTCs	-	REFER to the appropriate Engine Performance article.