LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1269 (Seating) >> Removal And Installation >> Seat Backrest Cover - Rear, Bucket >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the RH and LH armrests from the seat. For additional information, refer to Seat Armrest - Rear, Bucket .
  2. Release the J-clip at the lower edge of the backrest trim cover.
    3. CAUTION: Use care when separating the seat backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the seat backrest foam pad.
  3. Invert the backrest trim cover, release the hook-and-loop strips and remove.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals