LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1269 (Seating) >> Removal And Installation >> Seat Backrest Cover - Front >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Install a new crown washer when re-installing the armrest.
  1. Remove the armrest.
    1. Release the hook-and-loop at the rear of the armrest trim cover and access the armrest bolt.
    2. Remove the armrest bolt and crown washer.
      • To install, tighten to 35 Nm (26 lb-ft).
    3. Remove the armrest.
    2. Fig 1: Armrest Trim Cover & Bolt
    GF0011331Courtesy of FORD MOTOR CO.
  2. Remove the backrest trim cover.
    1. Release the J-clip at the bottom of the backrest.
      2. CAUTION: Use care when separating the seat backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the seat backrest foam pad.
    2. Invert the trim cover up the backrest, separate the hook-and-loop strips and remove the backrest trim cover.
    3. Fig 2: Backrest Trim Cover J-Clip
    GF0011332Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals