LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1269 (Seating) >> Disassembly And Assembly >> Seat Cushion - Rear, Bucket >> Disassembly And Assembly

Disassembly And Assembly

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the backrest. For additional information, refer to Seat Backrest - Rear, Bucket .
  2. Remove the seat track. For additional information, refer to Seat Track - Rear, Bucket .
  3. Remove the cushion trim cover. For additional information, refer to Seat Cushion Cover - Rear, Bucket .
  4. Remove the cushion foam pad.
    5. NOTE: The anti-rotation tab must be correctly aligned for correct installation.
  5. Remove the bolt and safety belt buckle.
    • To install, tighten to 40 Nm (30 lb-ft).
    6. Fig 1: Removing Bolt & Safety Belt Buckle
    GF0044462Courtesy of FORD MOTOR CO.
  6. To assemble, reverse the disassembly procedure.
scientia non olet · About LEMON Manuals