Seat Cushion - Front: Disassembly
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of serious personal injury or death.
WARNING:
To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious personal injury or death.
NOTE:
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON.
NOTE:
The supplemental restraint system (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
- Remove the seat. For additional information, refer to Seat - Front .
- Remove the seat backrest. For additional information, refer to Seat Backrest - Front .
- Remove the seat cushion. For additional information, refer to Seat Cushion - Front .
- Remove the power seat wiring assembly from the seat cushion.
- Remove the cushion trim cover.
- Release all cushion trim cover J-clips.
- Remove the cushion frame from the cushion foam pad and cushion trim cover.
- Separate the hook-and-loop strips and remove the cushion trim cover.
- To assemble, reverse the disassembly procedure.
NOTE:
Note the wiring harness pin-type retainer locations for assembly.