Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Right side shown, left side similar.

Remove the right front assist handle covers.

Fig 1: Right Front Assist Handle Covers

Courtesy of FORD MOTOR CO.

Remove the assist handle.
- Remove the 2 assist handle bolts and remove the assist handle.
  - To install, tighten to 12 Nm (9 lb-ft).

Fig 2: Right Front Assist Handle Bolts

Courtesy of FORD MOTOR CO.

NOTE: To release upper retaining clip, pull down at the top of the A-pillar trim panel.

Pull the A-pillar trim panel downward to release the remaining clips.

Fig 3: A-Pillar Trim Panel

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.