Vehicle Cold Soak Procedure
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
To carry out this procedure, proceed as follows:
- Test preparations include matching customer conditions (if known). If not known, document the test conditions: gear selection and engine RPM. Monitor the noise/vibration duration with a watch for up to 3 minutes.
- Park the vehicle where testing will occur. The vehicle must remain at or below the symptom temperature (if known) for 6-8 hours.
- Before starting the engine, conduct a visual inspection under the hood.
- Turn the key ON, but do not start the engine. Listen for the fuel pump, ABS and air suspension system noises.
- Start the engine.
- Isolate the noise/vibration by carefully listening. Move around the vehicle while listening to find the general location of the noise/vibration. Then, search for a more precise location by using a stethoscope or EngineEAR.
- If the source of the symptom has been identified as a result of this test, proceed to the appropriate part for further diagnosis and repair. If the source has not been identified, continue with the road test.