Satellite Audio Bezel Diagnostic Test
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
To enter the satellite audio bezel diagnostic test, the audio control module (ACM) must be on and in SAT mode.
- To enter the satellite audio bezel diagnostic test, simultaneously press and hold the SAT button and preset button 2 (except navigation), or press SOUND and preset button 1 (navigation).
- Upon entering the self-test, the ACM produces 2 continuously alternating tones of different pitch, one for the right channel, then one for the left.
- The test continues by displaying any DTCs currently present. If no DTCs are present, NO DTCS will be displayed. If there are DTCs present, the FDIM (or ACM) will auto-scroll through the list of active DTCs.
- Historical DTCs can be viewed by pressing the SAT button and preset button 2 (except navigation), or SOUND and preset button 1 (navigation) while in the active DTC mode.
- If any DTCs are present, pressing the SAT button and preset button 2 (except navigation), or SOUND and preset button 1 (navigation) will prompt CLEAR DTCS? to be displayed.
- To clear historical DTCs, press preset buttons 1, 2, and 3 consecutively within 4 seconds.
- To exit historical DTCs (with or without clearing DTCs), press the SAT button and preset button 2 simultaneously.
- If no historical DTCs are present, pressing the SAT button and preset button 2 (except navigation), or SOUND and preset button 1 (navigation) simultaneously while in active DTC mode will display the DLP software version.
- To exit the satellite audio bezel diagnostic test, press the SAT button and preset button 2 (except navigation), or SOUND and preset button 1 (navigation) simultaneously while the DLP software version is displayed, or turn the ACM off.
- If the concern remains and the fault is not detected, go to Symptom Chart - Audio System .