LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1203 (Engine - 3.0L (4V)) >> In-Vehicle Servicing >> Engine Oil Pressure (EOP) Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the pin-type retainer, 5 bolts and the RH lower splash shield.
    • To install, tighten to 9 Nm (80 lb-in).
    3. NOTE: Lubricate the engine oil filter gasket with clean engine oil prior to installing.
  3. Remove the engine oil filter.
    • To install, tighten to 5 Nm (44 lb-in) and then rotate an additional 180 degrees.
  4. Disconnect the engine oil pressure (EOP) switch electrical connector.
  5. Remove the EOP switch.
    • To install, tighten to 14 Nm (10 lb-ft).
  6. To install, reverse the removal procedure.
    • Apply Thread Sealant with PTFE to the EOP switch threads.
scientia non olet · About LEMON Manuals