Coolant Pump Belt: Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Install the coolant pump belt on the coolant pump pulley and position it on the camshaft pulley.

Fig 1: Locating Coolant Pump Belt On Coolant Pump Pulley

Courtesy of FORD MOTOR CO.

Remove the pin-type retainer, 5 bolts and the RH lower splash shield.

CAUTION: Do not use any screwdrivers, pliers or other metal objects that could cause damage to the belt or camshaft pulley while installing the belt.

Rotate the crankshaft clockwise to seat the coolant pump belt on the camshaft pulley.

Fig 2: Rotating Crankshaft Clockwise

Courtesy of FORD MOTOR CO.

Install the RH lower splash shield, pin-type retainer and 5 bolts.
- Tighten to 9 Nm (80 lb-in).