LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1190 (Rear Drive Axle/Differential) >> In-Vehicle Servicing >> Stub Shaft Seal >> Installation

Stub Shaft Seal: Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the new stub shaft seal with grease.
  1. Using the Front Axle Oil Seal Installer and Handle, install the stub shaft seal.
    2. Fig 1: Installing Stub Shaft Pilot Bearing Housing Seal
    GF0024594Courtesy of FORD MOTOR CO.
    NOTE: Inspect the inboard CV joint seal journal for rust or nicks/scratches prior to installing the halfshaft. If necessary, polish the seal journal with fine crocus cloth.
  2. Install the halfshaft assembly. For additional information, refer to REAR DRIVE HALFSHAFTS article.
scientia non olet · About LEMON Manuals