Instrument Cluster (IC): Removal
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- If installing a new instrument cluster (IC), upload the module configuration information to the scan tool. For additional information, refer to MODULE CONFIGURATION article.
- Lower the tilt steering column to the lowest position.
- Pull the instrument cluster (IC) finish panel straight out to release the retainer clips and remove the finish panel.
- Disconnect the instrument panel dimmer switch electrical connector and the ambient air temperature sensor (if equipped).
- Remove the 4 instrument cluster (IC) screws and the instrument cluster (IC).
- Disconnect the electrical connector.