LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1177 (HVAC Control System) >> Removal And Installation >> Clutch and Clutch Field Coil - 2.3L, 3.0L (4V) >> Removal

Clutch and Clutch Field Coil - 2.3L, 3.0L (4V): Removal

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the A/C compressor. For additional information, refer to Air Conditioning (A/C) Compressor - 2.3L  or Air Conditioning (A/C) Compressor - 3.0L (4V) .
  2. Remove the A/C clutch disc and hub bolt.
    1. Using a suitable spanner-type wrench, hold the A/C clutch disc and hub.
    2. Remove the A/C clutch disc and hub bolt.
    3. Fig 1: Identifying Wrench And Bolt
    GF0042577Courtesy of FORD MOTOR CO.
  3. Remove the A/C clutch disc and hub and the A/C clutch disc and hub spacer(s).
  4. Remove the A/C compressor pulley snap ring.
    5. CAUTION: Do not use air tools. Damage to the A/C clutch pulley or A/C compressor may result.
  5. Remove the A/C compressor pulley.
    1. Install the special tool.
    2. Install a suitable 3-jaw puller on the special tool and A/C compressor pulley.
    3. Remove the A/C compressor pulley.
    6. Fig 2: Identifying Special Tool (412-137) And A/C Compressor Pulley
    GF0042578Courtesy of FORD MOTOR CO.
  6. Remove the 4 A/C clutch field coil screws.
  7. Remove the A/C clutch field coil.
scientia non olet · About LEMON Manuals