Pinpoint Test R: An Individual Fog Lamp Is Inoperative
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.
NOTE:
Make sure the bulb is good before continuing diagnostics.
NOTE:
The battery ground cable must be disconnected for accurate test results when checking ground circuits for continuity to ground.
- R1 CHECK THE GROUND CIRCUIT FOR AN OPEN
- Key in OFF position.
- Disconnect: Inoperative Fog Lamp
- For Escape, measure the resistance between the LH fog lamp C1322-A, circuit GD120 (BK/GN), harness side and ground; or between the RH fog lamp C1323-A, circuit GD120 (BK/GN), harness side and ground
- For Mariner, measure the resistance between the LH fog lamp C152-1, circuit GD120 (BK/GN), harness side and ground; or between the RH fog lamp C162-1, circuit GD120 (BK/GN), harness side and ground
- Is the resistance less than 5 ohms?
- YES : REPAIR circuit CLF12 (BN/YE) for an open. TEST the system for normal operation.
- NO : REPAIR circuit GD120 (BK/GN) for an open. TEST the system for normal operation.