LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1166 (Wiper System And Washer System) >> Removal And Installation >> Wiper Blade - Rear >> Removal

Wiper Blade - Rear: Removal

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Lifting the wiper arm beyond its maximum angle may result in damage to the wiper arm or the wiper arm heel.
CAUTION: Allowing the wiper arm to contact the glass may result in damage to the glass.
  1. Hold the wiper arm with one hand close to the wiper arm and wiper blade pivot joint and lift the arm to its maximum angle.
  2. Hold the primary structure of the wiper blade with the other hand close to the wiper arm and wiper blade pivot joint.
  3. Tightly grip and push on the wiper arm and wiper blade joint from beneath and separate the blade from the arm.
  4. Fig 1: Identifying Wiper Arm Blade Joint
    GF0041905Courtesy of FORD MOTOR CO.