LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1165 (Body Panel System - Front End Body Panels) >> Removal And Installation >> Fender Splash Shield >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 3 fender splash shield bolts.
    • To install, tighten to 5 Nm (44 lb-in).
    2. Fig 1: Identifying Fender Splash Shield Bolts
    GF0041683Courtesy of FORD MOTOR CO.
  2. Remove the 7 fender splash shield pin-type retainers.
    3. Fig 2: Identifying Fender Splash Shield Pin-Type Retainers
    GF0041684Courtesy of FORD MOTOR CO.
  3. Remove the 6 fender splash shield screws.
    • To install, tighten to 5 Nm (44 lb-in).
  4. Remove the fender splash shield.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals