96,000 Km (60,000 Mi)
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Change engine oil and install a new oil filter.
- Change automatic transmission/transaxle fluid on all vehicles equipped with the TorqShift® and 4F27E transmissions.
- Install a new externally mounted remote filter element for all TorqShift® transmissions (if equipped).
- Install a new internal TorqShift® transmission fluid filter located inside the transmission bottom pan (vehicles without externally mounted remote filter only).
- Inspect automatic transmission/transaxle fluid level on all other vehicles (if equipped with an underhood fluid level indicator).
- Install a new cabin air filter (if equipped).
- Install new climate controlled seat cushion filters (if equipped).
- Install a new engine air filter.
- Install a new fuel filter (not required for Fusion, Milan, MKZ, Edge, MKX, Taurus X, Taurus and Sable).
- Replace wheel bearing grease and install new grease seals on RWD front wheel bearings (if non-sealed bearings).
- Inspect steering linkage, suspension and, if equipped, driveshaft, ball joints and U-joints.
- Inspect engine cooling system and hoses.
- Inspect brake pads, shoes, rotors, drums, brake lines, hoses and parking brake system.
- Inspect halfshaft boots (if equipped).
- Inspect exhaust system and heat shields.
- Inspect and lubricate ball joints and U-joints (if equipped with zerk fittings).
- Inspect and lubricate 4WD front axle shaft U-joints (if equipped).
- Carry out multi-point inspection (recommended).
- Rotate tires, inspect tires for wear, measure tread depth and inspect wheel ends for end play and noise. Vehicles with dual rear wheels should only be rotated if unusual wear is noted. For vehicles with different front-to-rear tire pressures, the tire pressure must be adjusted and the tire pressure sensor training must be done.