LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1093 (Bumper System) >> Removal And Installation >> Bumper - Rear >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear bumper cover. For additional information, refer to Bumper Cover - Rear .
  2. Remove the 4 rear bumper nuts.
    • To install, tighten to 25 Nm (18 lb-ft).
  3. Remove the rear bumper.
  4. If necessary, remove the rivets and the rear bumper isolator.
    • Use the special tool to install the new rivets.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals