Removal And Installation
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the windshield wiper mounting arm and pivot shaft. For additional information, refer to Wiper Mounting Arm and Pivot Shaft .
- Remove the wiper motor linkage bolt.
- To install, tighten to 17 Nm (13 lb-ft).
- Remove the 3 bolts and the wiper motor.
- To install, tighten to 15 Nm (11 lb-ft).
- To install, reverse the removal procedure.