LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1082 (Manual Transmission) >> In-Vehicle Servicing >> Halfshaft Seal >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: New halfshaft oil seals should be installed anytime the halfshafts are removed. Failure to install new halfshafts seals may result in transmission oil leak(s).
NOTE: RH intermediate shaft oil seal shown, LH halfshaft oil seal similar.
  1. Remove the RH intermediate shaft or LH halfshaft. For additional information, refer to FRONT DRIVE HALFSHAFTS article.
  2. Using the special tools, remove the RH intermediate shaft oil seal or the LH halfshaft oil seal.
    3. Fig 1: Removing Oil Seal
    GF0025323Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals