Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.

CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, wash it immediately with cold water.

Disconnect the clutch master cylinder hose from the brake master cylinder.
- Plug the brake master cylinder.
- Plug the clutch master cylinder hose.
Remove the 2 clutch master cylinder nuts.
- To install, tighten to 23 Nm (17 lb-ft).
Disconnect the clutch master cylinder push rod.
Disconnect the clutch hydraulic fluid tube fitting.
- Plug the clutch hydraulic fluid tube.
Remove the clutch master cylinder.
To install, reverse the removal procedure.
- Bleed the air from the system. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION AND CLUTCH - GENERAL INFORMATION article.