LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 107 (Driveshaft -- F250-F550 Super Duty) >> Disassembly And Assembly >> Driveshaft Slip Yoke - GKN >> Disassembly

Driveshaft Slip Yoke - GKN: Disassembly

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not clamp the driveshaft in the jaws of a vise or a similar holding fixture.
  1. Place the driveshaft on a suitable workbench.
  2. Index-mark the driveshaft slip yoke and the stub shaft.
    Fig 1: Index-Marking Driveshaft Slip Yoke And Stub Shaft
    G03918182Courtesy of FORD MOTOR CO.
  3. Remove the driveshaft slip yoke.
    1. Cut and discard the driveshaft slip yoke boot clamps.
    2. Separate the driveshaft slip yoke from the stub shaft.
      Fig 2: Removing Driveshaft Slip Yoke
      G03918183Courtesy of FORD MOTOR CO.
  4. Remove and discard the driveshaft slip yoke boot.
    Fig 3: Removing Driveshaft Slip Yoke Boot
    G03918184Courtesy of FORD MOTOR CO.
  5. Check the lubricant for contamination. If the lubricant feels gritty, clean and inspect the stub shaft and driveshaft slip yoke for wear. Install new components as necessary.
    Fig 4: Inspecting Stub Shaft And Driveshaft Slip Yoke
    G03918185Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals