Driveshaft Slip Yoke - GKN: Assembly

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fill the driveshaft slip yoke boot with approximately 10 grams (0.36 ounce) of grease.

Fig 1: Fill Driveshaft Slip Yoke Boot With Approximately 10 Grams (0.36 Ounce) Of Grease
Courtesy of FORD MOTOR CO.
Position the driveshaft slip yoke boot clamp on the stub shaft.

Fig 2: Positioning Driveshaft Slip Yoke Boot Clamp On Stub Shaft
Courtesy of FORD MOTOR CO.
Slide the driveshaft slip yoke boot over the stub shaft, and seat it in the boot groove.

Fig 3: Sliding Driveshaft Slip Yoke Boot Over Stub Shaft
Courtesy of FORD MOTOR CO.
Using the special tool, install the driveshaft slip yoke boot clamp.

Fig 4: Installing Driveshaft Slip Yoke Boot Clamp
Courtesy of FORD MOTOR CO.
Install the driveshaft slip yoke.
1. Position the driveshaft slip yoke boot clamp.
2. Lubricate the stub shaft splines with grease.
3. Align the index marks, and install the driveshaft slip yoke.
4. Seat the driveshaft slip yoke boot in the boot groove.
  
  Fig 5: Installing Driveshaft Slip Yoke
  Courtesy of FORD MOTOR CO.
Remove all excess grease from the slip yoke boot and the slip yoke.
Using the special tool, install both driveshaft slip yoke boot clamps. Tighten the tool until the clamp is secure.

Fig 6: Installing Driveshaft Slip Yoke Boot Clamps
Courtesy of FORD MOTOR CO.
Remove all excess grease from the slip yoke boot and the slip yoke.