LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1059 (Engine System - General Information) >> General Procedures >> Camshaft End Play - OHC Engines

Camshaft End Play - OHC Engines

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools

Illustration Tool Name Tool Number
GF0000024
 Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C) or equivalent
NOTE: Refer to the appropriate ENGINE article for the specification.
  1. Using the special tool, measure the camshaft end play.
  2. Position the camshaft to the rear of the cylinder head.
  3. Zero the indicator.
  4. Move the camshaft to the front of the cylinder head. Note and record the camshaft end play.
    • If camshaft end play exceeds specifications, install a new camshaft and recheck end play.
    • If camshaft end play exceeds specification after camshaft installation, install a new cylinder head.
    5. Fig 1: Using Dial Indicator Gauge With Holding Fixture To Measure Camshaft End Play
    GF0000178Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals