LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1052 (Engine Cooling - (Except Hybrid)) >> Removal And Installation >> Block Heater >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Drain the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding .
    3. CAUTION: Make sure that the block heater wiring is routed and secured away from rotating or hot components, or damage to the wiring can occur.
  3. Disconnect the block heater electrical connector.
  4. Remove the block heater.
    • To install, tighten to 21 Nm (15 lb-ft).
  5. To install, reverse the removal procedure.
  6. Fill and bleed the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding .
scientia non olet · About LEMON Manuals