LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Front Disc Brake System -- F250-F550 Super Duty) >> Removal And Installation >> Front Brake Pads >> Removal

Front Brake Pads: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
  1. Check the brake fluid level in the brake master cylinder reservoir.
    • If required, remove the fluid until the brake master cylinder reservoir is half full.
  2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
    3. CAUTION: Do not pry in the caliper sight hole to retract the pistons, as this can damage the pistons and boots.
    CAUTION: Do not allow the brake caliper to hang from the brake caliper flexible hose. Use a suitable tool to support the brake caliper.
    Fig 1: Removing 2 Brake Caliper Bolts And Position Caliper Aside
    G03919364Courtesy of FORD MOTOR CO.
  3. Remove the 2 brake caliper bolts and position the caliper aside.
  4. Remove the 2 brake pads and if equipped, remove the 4 retraction clips.
    • Discard the retraction clips.
      Fig 2: Removing 2 Brake Pads And 4 Retraction Clips
      G03919365Courtesy of FORD MOTOR CO.
  5. Measure the front brake disc thickness.
    • Install a new front brake disc if it is not within specification. Refer to BRAKE DISC .
    6. CAUTION: Install new brake pads if they are worn past the specified thickness above the metal backing plates. Install new brake pads in complete axle sets.
  6. Inspect the brake pads for wear and contamination.
scientia non olet · About LEMON Manuals