LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1040 (Engine - 3.0L (4V)) >> In-Vehicle Servicing >> Valve Cover - RH >> Removal

Valve Cover - RH: Removal

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, can cause engine failure.
  1. Remove the upper intake manifold. For additional information, refer to Upper Intake Manifold .
  2. Remove the RH ignition coil-on-plugs. For additional information, refer to ENGINE IGNITION - 3.0L (4V) article.
  3. Disconnect the positive crankcase ventilation (PCV) valve electrical connector.
  4. Disconnect the PCV tube from the PCV valve and position it aside.
  5. Disconnect the radio ignition interference capacitor electrical connector and detach the 3 wiring retainers from the stud bolts.
  6. Remove the nut and the radio ignition interference capacitor.
  7. Remove the 2 nuts and position the engine control harness aside.
  8. Remove the bolt, 9 stud bolts and the valve cover.
    • Remove and discard the gasket.
scientia non olet · About LEMON Manuals