Drive Pinion Seal: Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure that the mating surface is clean before installing the new seal.

Using the special tool, install the seal.

Fig 1: Installing Seal

Courtesy of FORD MOTOR CO.

NOTE: Lubricate the pinion flange with premium long-life grease.

Line up the index marks and position the pinion flange.

Fig 2: Marking Pinion & Yoke

Courtesy of FORD MOTOR CO.

Using the special tool, install the pinion nut.
- Tighten to 244 Nm (180 lb-ft).

Fig 3: Special Tool & Pinion Flange Nut

Courtesy of FORD MOTOR CO.

Line up the index marks and install the rear driveshaft universal joint.
- Install the 2 cap straps and the 4 bolts.
- Tighten to 23 Nm (17 lb-ft).

Fig 4: Bolts

Courtesy of FORD MOTOR CO.