LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1019 (Information Center (F250-F550)) >> General Procedures >> Compass Zone Adjustment

Compass Zone Adjustment

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Compass Calibration Zone Map
G03965509Courtesy of FORD MOTOR CO.
  1. The factory zone setting is set to Zone 8. Check the map to verify the correct compass zone setting for your geographic location.
  2. Turn the ignition switch to the RUN position.
  3. From the info menu, press and hold the SETUP and RESET buttons simultaneously until the message center shows the current zone setting.
  4. Release the SETUP and RESET buttons. Press the SETUP button until the correct zone setting is displayed.
  5. To exit the zone setting mode, and to lock in the change, press and release the RESET button.
scientia non olet · About LEMON Manuals