Positive Crankcase Ventilation (PCV) Heater Element - 5.4L: Installation
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Using a new O-ring seal, install the PCV heater element and the bolt.
- Tighten to 10 N.m (89 lb-in).
- Position the PCV tube and connect the quick connect couplings. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL article.
- Connect the PCV heater element electrical connector.
- Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
NOTE:
Lubricate the O-ring seal with clean engine oil prior to installation.