LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1727 (Front Suspension - Four Wheel Drive (4WD) -- F250-F550 Super Duty) >> Removal And Installation >> Wheel Studs >> Installation

Wheel Studs: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position a new wheel stud, aligning the serrations in the wheel hub made by the original stud.
  2. Place 4 washers over the outside end of the wheel stud and thread a standard wheel nut with the flat side against the washers. Tighten the wheel nut until the wheel stud seats against the back side of the wheel extension.
    3. Fig 1: Locating Wheel Nut And Washers
    GF0006168Courtesy of FORD MOTOR CO.
  3. Remove the wheel nut and washers.
    4. NOTE: Be sure to align index marks made during the removal step.
  4. Install the brake disc.
  5. Position the brake caliper and anchor plate assembly and install the 2 anchor plate bolts.
    • F-250 and F-350, tighten to 225 Nm (166 lb-ft).
    • F-450 and F-550, tighten to 400 Nm (295 lb-ft).
scientia non olet · About LEMON Manuals