LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1726 (Front Suspension - Rear Wheel Drive (RWD) -- F250-F550 Super Duty) >> Removal And Installation >> Wheel Studs - Single Rear Wheel (SRW) >> Installation

Wheel Studs - Single Rear Wheel (SRW): Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the new wheel stud in the wheel hub and brake disc assembly, aligning the serrations in the disc brake rotor flange made by the original wheel stud.
  2. Using a suitable press, install the new wheel stud.
    Fig 1: Installing Wheel Stud Into Brake Disc Using Suitable Press
    GF0006119Courtesy of FORD MOTOR CO.
  3. Install the wheel hub and brake disc assembly. For additional information, refer to Wheel Bearing and Wheel Hub - F-250, F-350  in this article.
scientia non olet · About LEMON Manuals