Wheel Bearings, Wheel Hub Seal and Wheel Bearing Cups: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

For model 80, using the special tools 205-098, 205-100, and 205-278, install the inner and outer bearing cups. For model S110 or S130, use a suitable driver.
- Check to see if a 0.038 mm (0.0015 inch) feeler gauge can be inserted between the cups and the rear hub at any point around each cup. Reseat the bearing cups, if necessary.
  
  Fig 1: Locating Inner And Outer Bearing Cups
  Courtesy of FORD MOTOR CO.
Install the inner rear wheel bearing in the rear hub.
Install a new rear hub seal.
- For model 80, use a suitable seal installer.
- For model S110 or S130, use special tools 205-445 and 205-153.
  
  Fig 2: Identifying Special Tool
  Courtesy of FORD MOTOR CO.
Position the rear brake disc on the rear hub and install the bolts.
- Tighten to 105 Nm (67 lb-ft).
  
  Fig 3: Locating Rear Hub Bolts
  Courtesy of FORD MOTOR CO.
Install the rear hub and brake disc assembly. For additional information, refer to WHEEL HUB .