Ball Joint: Removal

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the wheel spindle or wheel knuckle assembly. For additional information, refer to WHEEL SPINDLE - F-250, F-350 or WHEEL KNUCKLE - F-450, F-550 .
If equipped, remove the ball joint grease fitting.

Fig 1: Locating Ball Joint Grease Fitting
Courtesy of FORD MOTOR CO.
Position the front wheel spindle in a vise and remove the snap ring from the lower ball joint.

CAUTION: To avoid damage to the components, do not use heat to aid ball joint removal.

Fig 2: Removing Lower Ball Joint

Courtesy of FORD MOTOR CO.

Using the special tools, remove the lower ball joint.
Using the special tools, remove the upper ball joint.

Fig 3: Removing Upper Ball Joint
Courtesy of FORD MOTOR CO.